MyFloridaCode.com

I'd say, simply work with PGT engineering,  My experience has been 
that window company engineering departments are very accessible.  
You are fortunate in this case you are working with a Florida 
company - they will understand you more readily than 
out-of-staters.




On Sun Nov 16 07:13:49 CST 2008, Terrance Pitcher 
<ppitcher at cfl.rr.com> wrote:

> I have a frame building with a brick veneer It has a 1" space 
> between the two. The inspector is not allowing the window to be 
> installed because of the void. he says the window must be 
> supported fully for the 3.5 inches of the window thickness. The 
> outside is supported by the veneer and the inside is supported by 
> the drywall and the double studs underneath.The void is where the 
> screw holes are located.We wanted to drill other holes in further 
> to catch the studs and he said he needs engineering from the 
> manufacture PGT to allow this change.
> -------------- next part --------------
> An HTML attachment was scrubbed...
> URL: 
> http://myfloridacode.com/pipermail/codetalk/attachments/20081116/bf66e13e/attachment.html 
> _______________________________________________
> CodeTalk mailing list
> CodeTalk at myfloridacode.com
> Unsubscribe or change your options at:
> http://myfloridacode.com/mailman/listinfo/codetalk
> 
> 
>